Load Default Settings; Supervisor Password - ECS G43T-M3 Manual

38
Auto Detect DIMM/PCI Clk (Enabled)
When this item is enabled, BIOS will disable the clock signal of free DIMM/PCI slots.
Spread Spectrum (Enabled)
If you enable spread spectrum, it can significantly reduce the EMI (Electro-Magnetic
Interference) generated by the system.
Memory Voltage (1.90V)
This item allows users to adjust the DDR memory voltage.
NB Voltage (1.11V)
Use this item to adjust the Northbridge voltage.
Press <Esc> to return to the main menu setting page.

Load Default Settings

This option opens a dialog box to ask if you are sure to install optimized defaults or
not. You select [OK], and then <Enter>, the Setup Utility loads all default values; or
select [Cancel], and then <Enter>, the Setup Utility does not load default values.

Supervisor Password

This page helps you install or change a password.
CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Supervisor Password : Installed
Change Supervisor Password
Security Check
Supervisor Password (Installed)
This item indicates whether a supervisor password has been set. If the password has
been installed, Installed displays. If not, Not Installed displays.
Change Supervisor Password (Press Enter)
You can select this option and press <Enter> to access the sub menu. You can use the
sub menu to change the supervisor password.
Security Check (Setup)
If you have installed password protection, this item defines if the password is required
at system start up, or if it is only required when a user tries to enter the Setup Utility.
Press <Esc> to return to the main menu setting page.
Supervisor Password
Press Enter
Setup
: Move Enter : Select
+/-/: Value F10: Save ESC: Exit
F1: General Help
F9: Load Default Settings
Using BIOS
Help item
Install or Change the
password.