Checking Jumper Settings; Jumper Settings - ECS G43T-M3 Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type Description
CLR_CMOS 3-pin CLEAR CMOS
Front Panel
USBPWR_F 3-pin USB Power
Select Jumper
Rear USB/PS2
Power Select
USBPWR_R1/2 3-pin
Jumper
Rear USB/PS2
USBPWR_R3 3-pin Power Select
Jumper
To avoid the system instability after clearing CMOS, we recommend
1.
users to enter the main BIOS setting page to "Load Default Settings"
and then "Save & Exit Setup".
2. Make sure the power supply provides enough 5VSB voltage before se-
lecting the 5VSB function.
3. It is required that users place the USBPWR_F & USBPWR_R1~3 cap
onto 2-3 pin rather than 1-2 pin as default if you want to wake up the
computer by USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
2-3: CLEAR
Before clearing the
1
CMOS, make sure to
turn the system off. CLR_CMOS
1-2: VCC
1
2-3: 5VSB
USBPWR_F
1
1-2: VCC
2-3: 5VSB
USBPWR_R1/2
1-2: VCC
2-3: 5VSB
1
USBPWR_R3
9