Checking Jumper Settings; Jumper Settings - ECS 945GCD-M230 Manual

Checking Jumper Settings

The following illustration shows the location of the motherboard jumpers. Pin 1 is
labeled.

Jumper Settings

Jumper Type Description
CLR_CMOS 3-pin CLEAR CMOS
Rear USB/PS2
3-pin
USBPWR_F
Power Select
Jumper
Front Panel
USBPWR_R
3-pin
USB Power
Select Jumper
To avoid the system instability after clearing CMOS, we recommend users
1.
to enter the main BIOS setting page to "Load Default Settings" and
then "Save & Exit Setup".
2. Make sure the power supply provides enough VCC5_DUAL voltage be-
fore selecting the VCC5_DUAL function.
3. It is required that users place the USBPWR_F & USBPWR_R cap onto 2-
3 pin rather than 1-2 pin as default if you want to wake up the computer
by USB/PS2 KB/Mouse.
Installing the Motherboard
Setting (default)
1-2: NORMAL
2-3: CLEAR
Before clearing the 1
CMOS, make sure to
CLR_CMOS
turn the system off.
1-2: VCC5
1
2-3: VCC5_DUAL
USBPWR_F
1
1-2: VCC5
2-3: VCC5_DUAL
USBPWR_R
9