Advanced Chipset Setup - ECS MCP61M-M3 Manual

Advanced Chipset Setup

This page sets up more advanced information about your system. Handle this page
with caution. Any changes can affect the operation of your computer.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Dram Frequency
Dram Timing
DCT Unganged Mode
Share Memory Auto Detection
Share Memory Size
: Move Enter : Select
F1:General Help
Dram Frequency (Auto)
This item enables users to adjust the DRAM frequency. The default setting is auto and
we recommend users leave the setting unchanged. Modify it at will may cause the
system to be unstable.
DRAM Timing (Auto)
This item allows you to enable or disable the DRAM timing defined by the Serial
Presence Detect electrical. Users please note that if setting this item to auto, the
following two items are not available.
DCT Unganged Mode (Always)
This item is used to select the DCT mode (DRAM Controller mode).
Share Memory Auto Detection (Auto)
Disable this item to set the Share Memory Size. And if the item is set to Auto, Share
Memory Size can be controlled according to the dram size:
When the dram size is less than 512 MB, Share Memory Size should be set to 32
MB;
When the dram size is over 512MB, and it is dual channel, Share Memory Size
should be set to 64 MB;
When the dram is single channel, its size is over 512MB: if the memory frequency
is 667MHz, Share Memory Size should be set to 64 MB; if the memory frequency
is 533MHz or 400MHz, Share Memory Size should be set to 32 MB.
Share Memory Size (64 MB)
This item displays the VGA Share Memory value size.
Advanced Chipset Setup
Auto
Auto
Always
Auto
Auto
64MB
Limit
Manual
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
33
Help Item
Options