Table of Contents
Advertisement
Step 5: Install the
external Audigy
Drive
Step 6: Connect the
CD-ROM/DVD-
ROM drive
If the Sound Blaster Audigy
card is connected to both the CD
SPDIF and CD Audio
connectors on a CD-ROM or
DVD-ROM drive, do not enable
the CD Audio and CD Digital
options at the same time in
Surround Mixer.
1. Attach the SB1394 connector on the Audigy Extension cable
to the SB1394 Extension ports on the Audigy Extension card
and external Audigy Drive as shown in Figure 2-6.
2. Attach the 44-pin DB connector on the Audigy Extension
cable to the Audigy Extension connectors on the Audigy
Extension card and External Audigy Drive.
3. If you are installing a joystick or a MIDI device, connect the
Joystick/MIDI connector on the Audigy Extension cable to
the device.
For analog CD audio output:
connect the Analog CD audio cable (not included) from the
Analog Audio connector on your CD-ROM/DVD-ROM drive
to the CD_IN connector on the Sound Blaster Audigy card as
shown in Figure 2-7.
For digital CD audio output:
connect the Digital CD audio cable from the Digital Audio
connector on your CD-ROM/DVD-ROM drive to the
CD_SPDIF connector on the Sound Blaster Audigy card.
Audigy Extension card
1
2
3
Rear panel of external
Audigy Drive
1
2
Figure 2-6: Connecting the cables to the externa
Audigy Drive.
CD-ROM/DVD-ROM drive
1
2
OR
Sound Blaster Audigy card
Figure 2-7: Connecting CD-ROM/DVD-ROM
drives.
Installing Hardware 2-6
Advertisement
Table of Contents
