Installation - Binatone Terrain 750 User Manual

2. Installation

2.1 Removing the Belt Clip
a. Pull the Belt Clip latch forward
(away from the PMR.)
While pulling the Belt Clip
b.
latch, push up the Belt Clip
as shown in Figure 1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure 2.
A "click" indicates the Belt
b.
Clip is locked into position.
2.3 Installing the Battery pack
Figure 3
Caution: Observe the proper battery polarity orientation when
installing batteries. Incorrect positioning can damage both the
batteries and the unit.
Unclip the battery cover latch at the bottom of the cover, and lift
a.
the battery cover off.
Install the rechargeable battery pack by following the orientation as
b.
shown in Figure 3 (the arrow is showing and pointing upward.)
c. Replace the Battery Compartment Cover. See Figure 4.
Read these Safety Warnings before you charge the batteries.
When placing the PMR in the charger,
batteries supplied with the Terrain 750.
Don't try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in
place when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment -
they could get burnt or punctured.
Don't leave dead batteries in your PMR units.
They might leak if you do.
2.4 Charging the Battery pack
a. Insert the small plug on the end of the mains adaptor into the
Power-in Connection Jack at the back of the desktop charger.
Plug the mains adaptor into a 240V AC, 50 Hz main socket with
b.
the switch on the socket set to OFF.
Switch ON the main socket.
c.
The PMR must be charged using the mains adaptor provided.
Using any other adaptor will result in non-compliance with
EN60065 and will invalidate any approvals & warranty.
Figure 1
Figure 4
b
Important
never try to burn them or put them anywhere,
Belt Clip
latch
Figure 2
c
use only the rechargeable