Installation - Binatone Action 1100 User Manual

2. Installation

2.1 Removing the Belt Clip
a. Pull the Belt Clip latch up
(away from the Action 110 0)
b. While pulling the Belt Clip
latch, slide the Belt Clip up as
shown in Figure1.
2.2 Installing the Belt Clip
a. Slide the Belt Clip into the
slot as shown in Figure2.
A "click" indicates the Belt
Clip is locked into position.
2.3 Installing the Batteries
Caution: Observe the correct battery orientation when installing
the batteries. Incorrect installation can damage both the
batteries and the unit.
a. Remove the belt clip, unclip the latch at the bottom and remove
the cover.
b.
Insert the 4 "AAA" size rechargeable batteries by following the
+ /- polarity marking s inside the Battery Compartment as shown
in Figure 3.
c.
Replace the Battery Compartment cover and push the latch back
up until it clicks into place. See Figure 4.
Read these Safety Warnings before you charge the batteries.
When placing the Action1100 in the charger, use only the power
ly
supp supplied with the Action 1100.
Don't try to recharge non-rechargeable batteries.
Make sure the battery compartment cover is securely locked in
place when you are charging the batteries.
Dispose of used batteries safely and in a way that will not harm
the environment- never try to burn them or put them anywhere they
could get burnt or punctured.
Don't leave dead batteries in your Action 1100 units. They might
leak if you do and damage the Action 1100.
Binatone Help Line - 0845 345 9677
Helpline No. UK/Nor ther n Ir ela nd
http://www.binatoneonline.com/
Web Support
Figure 1
Figure 3
Important
08453459677
Belt Clip latch
Figure 2
Figure 4
0818762092
02