Bluetooth Connection - JVC KD-R80BT Instruction Manual

Bluetooth connection

3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below
(A)
Pairing?
Device: [Device name]
Passkey: XXXXXX
"XXXXXX" is a 6-digit passkey randomly
generated during each pairing.
Ensure that the passkey which appears
on the unit and Bluetooth device is the
same.
Select "Yes" to confirm the passkey.
Operate the Bluetooth device to confirm
the passkey.
After pairing is successful, "Pairing COMPLETED" appears on the display.
The unit will establish a connection with the newly paired Bluetooth device and you can then control
the Bluetooth device through the unit.
" " will light up when a phone is connected.
" " will light up when an audio device is connected.
Once the connection is established, the device is registered to the unit and there is no need to
perform the pairing again unless you delete the registered device.
Some Bluetooth devices may not be able to connect to the unit after pairing. Connect the device to
the unit manually. Refer to the instruction manual of the Bluetooth device for more information.
Connecting/Disconnecting a registered device manually
To connect
1
(Hold)
2 Select <Connect>.
3 Select the desired device.
"Connecting..." appears on the display when the
unit is connecting to the device.
"Connected" "[Device Name]" appears on the
display when the device is connected.
4 Press MENU to exit.
16 | ENGLISH
Pairing?
Yes: Press VOL
No: Press BACK
<Bluetooth>
<Phone>/<Audio>
<Connect>
(B)
Pairing?
Device: [Device name]
(1) When the Bluetooth device prompts
you to key in a PIN or passcode, enter the
PIN code "0000" into the Bluetooth
device. The above should then appear on
the display.
You can change to a desired PIN code before
pairing. ( page 26)
(2) If only "Pairing" appears, operate the
Bluetooth device to confirm pairing.
Select "Yes" to confirm the pairing.
To disconnect
1
(Hold)
2 Select <Disconnect>.
3 Select the desired device.
"Disconnected" "[Device Name]" appears on the
display when the device is disconnected.
4 Press MENU to exit.
Pairing?
Yes: Press VOL
No: Press BACK
<Bluetooth>
<Phone>/<Audio>
<Disconnect>