Bluetooth Connection - JVC KD-R80BT Instruction Manual

Bluetooth connection

By connecting the supplied KS-UBT1 USB Bluetooth Adapter* and microphone* to this unit, you can
operate a Bluetooth device using this unit. Refer to the "Installation/Connection Manual" for details on
connecting the microphone.
Once the USB Bluetooth Adapter is attached, this unit is always
available for pairing.
Refer also to the instructions supplied with the Bluetooth
device.
Refer to the separate appendix to check the countries where
you may use the Bluetooth function.
If you turn off the unit, detach the control panel, or unplug the USB Bluetooth Adapter during a
phone call conversation, the Bluetooth connection is disconnected. Continue the conversation using
your mobile phone.
* KD-R80BT only. KS-BTA50 Accessory Kit (USB Bluetooth Adapter and microphone) available
separately for KD-A65/KD-R60.
This unit supports the following Bluetooth profiles
Hands-Free Profile (HFP 1.5)
Object Push Profile (OPP 1.1)
Phonebook Access Profile (PBAP 1.0)
Advanced Audio Distribution Profile (A2DP 1.2)
Audio/Video Remote Control Profile (AVRCP 1.3)
Warning:
Stop the car in a safe place before operating complicated steps such as dialing numbers, using
phonebook, etc.
Pairing a Bluetooth device
When connecting a Bluetooth device to the unit for the first time, perform pairing between the unit and
the device.
Up to five Bluetooth devices can be registered in this unit.
A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
This unit supports Secure Simple Pairing (SSP).
1 Connect the USB Bluetooth adapter
(KS-UBT1) to one of the USB input
terminals.
2 Search and select "JVC Unit" on the Bluetooth device.
For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN) code
immediately after searching.
Bluetooth connection
KS-UBT1 Microphone
USB cable from the
rear of the unit
KS-UBT1
or
ENGLISH | 15