Switching Input Signal - BenQ MW767 User Manual

Disabling the password function
To disable password protection, go back to the
Security Settings > Change Security Settings > Power on Lock menu after
opening the OSD menu system. Select Off by pressing
PASSWORD' displays. Enter the current password.
• If the password is correct, the OSD menu returns to the Security Settings
page with 'Off' shown in the row of Power on Lock. You will not have to enter
the password next time you turn on the projector.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You
can press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old password in hand should you
ever need to re-activate the password function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can only
display one full screen at a time. When starting up, the projector automatically searches for
the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the
default of this projector) if you want the projector to automatically search for the signals.
You can also manually cycle through the available
input signals.
1. Press SOURCE on the projector or remote
control. A source selection bar displays.
2. Press
selected and press MODE/ENTER.
Once detected, the selected source information
will display on the screen for seconds. If there is
multiple equipment connected to the projector,
repeat steps 1-2 to search for another signal.
• The brightness level of the projected image will
change accordingly when you switch between
different input signals. Data (graphic) "PC"
presentations using mostly static images are
generally brighter than "Video" using mostly
moving images (movies).
• The input signal type effects the options available
for the Picture Mode. See
mode" on page 39
• The native display resolution of MX766/MX822ST
is in a 4:3 aspect ratio while the native display
resolution of MW767 is in a 16:10 aspect ratio. For
best display picture results, you should select and use an input signal which outputs at this
resolution. Any other resolutions will be scaled by the projector depending upon the 'aspect
ratio' setting, which may cause some image distortion or loss of picture clarity. See
"Selecting the aspect ratio" on page 38
Changing Color Space
36
Operation
/ until your desired signal is
"Selecting a picture
for details.
SYSTEM SETUP: Advanced
/ . The message 'INPUT
for details.
>