Toshiba e-STUDIO400P Management Manual page 86

2 SETTING ITEMS (ADMIN)
2
Specify the following items as required and complete the setting.
1) Press the desired period of time (in minutes) that this equipment should wait before the sleep or super sleep
mode is activated.
2) Select whether this equipment enters the sleep mode or the super sleep mode when a specified period of time
has passed. When [Enable] is selected, this equipment enters the super sleep mode.
3) Press [OK].
The equipment may not enter this mode at the set timing depending on its operating status.
When any of the options such as the Wireless LAN Module, Bluetooth Module, Data Overwrite Enabler or
e-BRIDGE ID Gate is installed in this equipment or when the optional IPsec feature is enabled, this
equipment does not enter the super sleep mode even if [ENABLE] is selected for this setting.
For protocols available for recovering this equipment from the super sleep mode, refer to the TopAccess
Guide.
84 Setting General Functions