Forget To Add A Dish; At The End Of The Wash Cycle - Baumatic BDW2SS Instruction Manual

BAUMATIC BDW2W / BDW2SS
A FORGOTTEN DISH CAN BE ADDED AT ANY TIME BEFORE THE DETERGENT
DISPENSER OPENS.
OPEN THE DOOR A LITTLE TO STOP THE WASHING.
•
WAIT ABOUT TEN SECONDS. AFTER THE SPRAY ARMS STOP WORKING,
•
YOU CAN OPEN THE DOOR COMPLETELY.
ADD FORGOTTEN DISHES.
•
CLOSE THE DOOR, THE DISHWASHER WILL WORK AFTER TEN SECONDS.
•
NEED TO INTERRUPT A CYCLE?
If an emergency arises, you can stop the machine at any time by pressing the
ON/OFF button. Remember to wait approx. 10 seconds before you open the door fully,
as the spray arms continue to turn after the power has been cut and could spray hot
water up at you. DO NOT TURN THE KNOB AHEAD AS THIS WILL AFFECT THE
WASHING RESULT! YOU ALSO COULD JUST PULL THE DOOR OPEN – DO NOT
If you need to change a cycle, you can as long as the dishwasher has only been
running for a short time. Just press the ON/OFF button so the ON light goes out, turn
the knob to the setting you want then turn the dishwasher back on with the ON/OFF
button.
However, if it's been a long time since the old cycle began, the detergent may have
already been released and the wash water drained out. You'll need to start a new cycle
altogether so press the 'ON/OFF' button to switch the dishwasher off, wait until the inside
cools before you refill the detergent dispenser, close the door and then turn the knob to
the cycle setting you want before you turn your dishwasher back on.
WASHING. THE HOT WATER MAY SCALD YOU!

AT THE END OF THE WASH CYCLE

When the knob stops turning and lines up with the STOP mark (see figure), the
cycle has finished. Turn the dishwasher off using the ON/OFF button and open the door of the
dishwasher. Wait a few minutes before unloading the dishwasher so the dishes can cool down.
This will make them less breakable and allow them to dry better.

FORGET TO ADD A DISH?

TOUCH ANY BUTTONS!
NOTE:
TAKE CARE WHEN OPENING THE DOOR DURING
14
dishwasher user manual 14