Table of Contents
Advertisement
6. Starting a Washing Programme
Wash cycle table
Cycle Selection
Program
Information
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
Intensive
on them for a while.
For heavy soiled loads,
such as pots, plates, glasses
and lightly soiled pans.
Heavy
standard daily cycle.
For normally soiled loads,
such as pots, plates, glasses
Normal
and lightly soiled pans.
(AS/NZS 2007.1)
Standard daily cycle
For dishes that need to be
rinsed and dried only
Rinse
A shorter wash for lightly
soiled loads that do not
Rapid
need drying.
To rinse dishes that you
plan to wash later that day
Soak
AS/NZS 2007.1:This programme is the test cycle. The information for comparability test
in accordance with AS/NZS.2007.1, as follows:
- Capacity: 14 settings
- Position of Upper basket: Low position
- Rinse aid setting:5(or 4 for four setting dispenser)
We recommend you open the door slightly 50 mm to assist in drying of the dishes
NOTE:
after every wash.
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent.
2. Insert the plug into the socket. The power supply is 220V-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the "Power"
button, press the programme button to select a desired "Wash cycle". (See the section entitled
"Wash Cycle Table".) .
NOTE:
A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing "Power" button.
12
Running
Description
Energy
Detergent
Time
of Cycle
Pre/main
(kWh)
(min)
Pre-wash(40 )
Main wash(55 )
Rinse 1
5/27.5g
150
1.35
Rinse 2
(or 3in1)
Hot rinse(65 )
Drying
Main wash(60 )
Rinse 1
Rinse 2
5/27.5g
135
1.25
(or 3in1)
Hot rinse(65 )
Drying
Main wash(45 )
Rinse
5/27.5g
113
0.83
Hot rinse(50 )
(or 3in1)
Drying
Pre-wash
Hot rinse(70 )
67
0.85
Drying
Main wash(40 )
20g
50
0.60
Hot rinse(50 )
Pre-wash
8
0.07
Switching on
1. Open the tap, if it is closed.
2. Close the door.
3. Make sure the spray arms are not obstructed.
4. Switch the dishwasher on using the "Power" button.
Water
The additional indicators, delay start indicators and status indicator could light up eriodically
(L)
one bye one.
Select a programme
Choose your programme according to the type of load and how dirty it is.
20.0
The different programmes and their uses are described in the programme chart later on in this
booklet. Use the programme selector to select the expected programme .
Change the Programme.
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
16.0
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
Press the "Power" button and turn on it again. Press the "programme" button to choose the expected
13.7
cycle setting (see the section entitled "Starting a wash cycle. . . " ).
NOTE: If you open the door when the washing cycle underway, the appliance will pause and emit
warning signals, the display appears E1. When you close the door, the machine will keep on working
8
after 10 seconds.
The 6 programme lights show the state of the dishwasher :
a) One of the programme lights on --> cycle running
8
b) One of the programme lights bliking--> pause
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.
4.0
Forget to Add Dish
A forgotten dish can be added any time before the detergent cup opens.
1Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the "Power" button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
p
13
Hide quick links:
Advertisement
Table of Contents
