Obtaining Documentation - Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual

Route switch processor

Hide thumbs

Table of Contents

Router #

Enter the show startup-config EXEC command to display the enable password in the configuration file.

Step 11

Enter the configure terminal command at the EXEC prompt. You are prompted as follows:

Step 12

Router# configure terminal

Enter configuration commands, one per line.

Router(config)#

Using the config-register 0x value command, change the configuration register value back to its original

Step 13

value (noted from Step 3) or change it to a value of 0x0101 (the factory default).

Exit the configuration mode by entering Ctrl-Z.

Step 14

Reboot the router and enable it using the recovered password.

Step 15

This completes the procedure for recovering from a lost password.

Using Flash Memory

The Flash memory (PC Card) slots on the front panel of the RSP2 support additional PC Card-based

Flash memory media for your system. You can use this Flash memory to store and run IOS software

images, or as a file server for other routers to access as clients.

A complete discussion of PC Card-based Flash memory is beyond the scope of this publication. For

Note

detailed information on Flash memory cards, refer to the configuration note Flash Memory Card

Installation Instructions (Document Number 78-2083-xx, where xx is the latest version of this

document). For detailed information on Flash Disks, refer to the configuration note Using the Flash Disk

(Document Number 78-5819-xx, where xx is the latest version of this document).