Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual page 28

Standard 16-, and 20-MB Flash memory cards are supported with the RSP2 (The 20-MB Flash memory
Note
card is currently the default.). See
You should specify slot0 or slot1 in your command, depending on which slot you are using.
Standard 48- and 128-MB Flash Disks are supported with the RSP2. See
additional information. You should specify slot0 or slot1 in your command, depending on which slot
your are using.
The following example ensures that both RSPs have the same system image. Note that because no
environment variables are set, the default environment variables are in effect for both the active and the
standby RSP.
Router# show bootvar
BOOT variable =
CONFIG_FILE variable =
Current CONFIG_FILE variable =
BOOTLDR variable does not exist
Configuration register is 0x0
Slave auto-sync config mode is on
current slave is in slot 7
BOOT variable =
CONFIG_FILE variable =
BOOTLDR variable does not exist
Configuration register is 0x0
Router# dir slot0:
-#- -length- -----date/time------ name
1 3482498
7993896 bytes available (1496 bytes used)
Router# dir slaveslot0:
-#- -length- -----date/time------ name
1 3482498
7993896 bytes available (1496 bytes used)
Router# delete slaveslot0:rsp-k-mx11.1
Router# copy slot0:rsp-k-mx11.2 slaveslot0:rsp-k-mx11.2
28
Flash Memory Card Installation Instructions
May 4 1999 21:38:04 rsp-k-mx11.2
May 4 1999 21:38:04 rsp-k-mx11.1
for detailed information.
Using the Flash Disk for
OL-4923-01 B0