Cisco RSP2 - Route Switch Processor 2 Installation And Configuration Manual page 84

Configure the terminal to operate at 9600 baud, 8 data bits, no parity, 2 stop bits (or to whatever settings
Step 2
the router is set).
Enter the show version command to display the existing configuration register value. Note this value for
Step 3
later use in Step 13.
Step 4 If the Break function is disabled, power cycle the router. (To power cycle, turn off the router, wait five
seconds, and then turn it on again.) If the Break function is enabled on the router, press the Break key or
send a break (^[) and then proceed to Step 5.
Within 60 seconds of turning on the router, press the Break key. This action causes the terminal to display
Step 5
the bootstrap program prompt:
rommon 1 >
Set the configuration register to ignore the configuration file information as follows:
Step 6
rommon 1 > confreg
Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-RSP
do you wish to change the configuration? y/n [n]: y
enable "diagnostic mode"? y/n [n]:
enable "use net in IP bcast address"? y/n [n]:
enable "load rom after netbootfails"? y/n [n]:
enable "use all zero broadcast"? y/n [n]:
enable "break/abort has effect?" y/n [n]:
enable "ignore system config info?" [n]: y
change console baud rate? y/n [n]:
change boot characteristics? y/n [n]
Configuration Summary
enabled are:
console baud: 9600
boot: image specified by the boot system command
or default to: cisco2-RSP
do you wish to change the configuration? y/n [n]
You must reset or power cycle for the new config to take effect
Initialize the router by entering the i command as follows:
Step 7
rommon 1 > i
The router power cycles, the configuration register is set to ignore the configuration file, and the router
boots the boot system image and prompts you with the system configuration dialog as follows:
Enter no in response to the system configuration dialog prompts until the following system message is
Step 8
displayed:
Press RETURN to get started!
Step 9 Press Return. After some interface information, the prompt appears as follows:
Router >
Enter the enable command to enter the enabled mode. The prompt changes to the following:
Step 10
84
--- System Configuration Dialog ---
OL-4923-01 B0