Table of Contents
Advertisement
3. Use a screwdriver to remove the two metal knockouts.
4. Insert the rope clip through the rear panel; then, attach and tighten the nuts.
5. Thread the cable through the rope clip and around an object that is not part of
or permanently secured to the building structure or foundation, and from which
the cable cannot be removed. Fasten the cable ends together with a lock. After
you add the security cable, be certain it does not interfere with other cables that
are connected to the computer.
Rope clip
6. If you have other options to install or remove, do so now; otherwise, go to
"Completing the installation" on page 40.
Replacing the bezel
To replace the bezel, complete the following steps:
1. Insert the two tabs on the bottom of the bezel into the matching holes on the
computer chassis.
2. Push the top of the bezel toward the computer until the two tabs at the top of
the bezel snap into place.
Chapter 2. Installing the hardware
39
Advertisement
Table of Contents
