Ariens 920402 – Sno-Tek 24E Owner's/Operator's Manual page 25

Roller should be 1/2 – 7/8 in. (12.7 –
22.2 mm) from the frame when the
attachment clutch is engaged.
Figure 25
Adjust the Attachment Clutch Cable
Spring Extension
(Figure 26)
1. Check the attachment clutch cable
spring extension.
Measure the length of the attachment
clutch cable spring with the clutch lever
disengaged.
Then measure the attachment clutch
spring with the clutch lever engaged.
The spring should be 1/2 – 9/16 in. (12.7
– 14.3 mm) longer when the clutch lever
is engaged.
• If spring extension is within the
specified range, go to Check
Attachment Brake on page 25.
• If spring extension is outside of
specified range, go to step 2.
1/2 – 9/16 in.
(12.7 – 14.3 mm)
Figure 26
2. Adjust cable length (Figure 26).
Check Attachment Brake
(Figure 27)
1. With the clutch lever disengaged, brake
pad must contact attachment belt. With
OS8080
clutch lever engaged, brake pad must be
more than 1/16 in. (1.6 mm) from belt. If
there is more than 1/16 in. (1.6 mm) gap,
go to Check Belt Finger Clearance on
page 26. If there is less than 1/16 in. (1.6
mm) gap, go to Step 2.
1. Brake Arm and Pad
2. Attachment Pulley
2. If there is less than 1/16 in. (1.6 mm)
gap between brake pad and belt, follow
these steps:
OS8085
IMPORTANT: If adjustments cannot be
brought into specified ranges see your dealer
for repairs.
GB - 25
a. Loosen jam nut on cable.
b. To increase spring extension,
adjust barrel down the cable and
tighten jam nut.
c. To decrease spring extension,
adjust barrel up the cable and
tighten jam nut.
Minimum of 1/16 in. (1.6 mm)
2
Figure 27
a. To increase brake pad gap,
loosen idler adjustment nut, and
move idler away from belt.
Position idler to achieve a 1/16 in.
(1.6 mm) minimum brake pad
gap and a 1/2 – 7/8 in. (12.7 –
22.2 mm) gap between the
plastic roller and the frame.
b. Check the clutch cable spring
extension and adjust as
necessary to achieve a 1/2 –
9/16 in. (12.7 – 14.3 mm) spring
extension.
c. If the cable needed adjustment,
recheck gaps described in step 1.
Repeat steps as necessary until
brake clearance, roller gap and
spring extension are within
specified ranges.
1
OS8092