Installing An Optical Drive Into The 5.25-Inch Drive Bay - HP MultiSeat ms6000 Maintenance And Service Manual

6. Rotate the drive cage back down to its normal position.
CAUTION:
Figure 5-20
7. Press down on the green drive retainer button located on the left side of the drive to disengage
the drive from the drive cage (1). While pressing the drive retainer button, slide the drive back
until it stops, then lift it up and out of the drive cage (2).
Figure 5-21
NOTE: To replace the drive, reverse the removal procedure. When replacing a drive, transfer the
four guide screws from the old drive to the new one.

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:
1. Prepare the computer for disassembly
2. Remove the access panel
3. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank. See
52 Chapter 5 Removal and Replacement Procedures
Be careful not to pinch any cables or wires when rotating the drive cage down.
Rotating the Drive Cage Down
Removing the 5.25-inch Drive
(Access Panel on page
Bezel Blanks on page 35
(Preparation for Disassembly on page
32).
for more information.
32).