Kenmore 2029319 - Canister Vacuum Use And Care Manual page 17

Always follow allsafety p recautions when p erforming maintenance onthe Power-Mate
i i i i i lu uluiJllUtlrltlruJJJHlluluuur,
,d WARNING
Electrical Shock Or Personal Injury Hazard°
Disconnect electrical supply before performing maintenance to the vacuum cleaner,
Failure to do so could result in electrical shock or personal injury from vacuum cleaner
suddenly starting°
I CHA.O,.OANO.O'TATO" ,.O
TO REMOVE BELT m REPLACE BELT
Mate upside motor drive,
_,_F" down
_,._.
then over
'%_y_f ..=iJ_\_"
2. Unscrew two (2) belt path., _.__ 'y Mo%r
._ _ screwsP°wer'Mate cover _V'\__End Cap PBaeli-
NOTE: See
PARTS AND
FEATURES for
Belt number
latches up
Latch Latches
and remove
worn belt,
4.,To remove cover,
grasp the sides and
pull out,
End Cap
6. Check and clean end cap areas. See TO
CLEAN AGITATOR section and AGITATOR
ASSEMBLY illustration for picture of
complete agitator assembly.
2, Place agitator
assembly back
into PoweFMate
3oLine up front
of cover and
base, Rest
cover on front
edge of base as
shown.
Cover Base
4oRotate cover
back Press
'_--'----____,_.. cover firmly untif
___/=:_.._:4_lde and rear
_'__, 7-"_ latches snap into
\ - .V place
Side Rear
Latch Latches
Make sure there is no gap between the
cover and base
5, Turn Power-Mate upside down and
replace two (2) cover screws
'I7