Motor Safety Filter Cleaning; Exhaust Filter Changing - Kenmore 2029319 - Canister Vacuum Use And Care Manual

MOTOR SAFETY FILTER CLEANING
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner
from electrical outlet. Do not operate
the vacuum cleaner without the motor
safety filter,, Be sure the filter is dry and
properly installed to prevent motor
failure and!or electrical shock.
JUIUJIJIHUI,nl
Check motor safety filter occasionally
and clean when dirty.
l oRemove the bag as outlined in the BAG
CHANGING section
2. Lift the rubber
retainer and pull
out motor safety filter
as shown
3. Wash filler in warm soapy water, rinse,
then dry, Do not clean in dishwasher or
install while damp.
._j_i_._._._ '_ 4. Rep,ace the filter .....by sliding it back into
___ place under the ribs
__ in the bag cavity
_-'_'q"_ j !llt_l_,:{_[_ Tuck filter in so that it
_#._,rs,_ fits completely under
_)tai_er_ -_ the rubber retainer.
5. Replace the bag as outlined in the BAG
CHANGING section,,
EXHAUST FILTER CHANGING
kWARNING
Fire andlor Electrical Shock Hazard
Do not operate with a clogged exhaust
filter or without the exhaust filter or
exhaust filter cover installed.
HEPA EXHAUST FILTER
The exhaust filter cartridge must be
replaced when dirty Replace the filter when
the entire surface area is covered evenly,
The filter CANNOT be washed as it will
lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for
Exhaust Filter number_
t, Pull out and
up on the
exhaust filter
cover to remove
from the
canister and lay
aside,,
16
3. Replace exhaust
filter cartridge,
Place the new filter
cartridge into the
canister with the
foam seal facing
down towards the
canister
Tabs
2oPull the exhaust
filter cartridge up
and out from the
rear of the
canister
Filte_
4. Replace the
exhaust filter cover
by placing the two
tabs on the filter
cover into the slots
on the canister and
rotate into place
until it snaps
closed.