Attach Handle To Vacuum; Attach Vacuum Hose And Tools - Bissell PowerForce Helix Turbo Bagless User Manual

A
ssembly

Attach handle to vacuum

1.
Locate handle and remove screw packet
taped to the user's guide.
2.
Stand the vacuum upright and place the
base of the handle firmly into the grooves
at the top of the vacuum body.
3.
Insert the two (2) screws into the existing
holes on each side and tighten securely.

Attach vacuum hose and tools

4.
Line up tabs on the base of the Twist
'n Snap™ hose with the corresponding
notches on the hose collar. Turn the hose
to the right to lock into place.
5.
Grasp the hose wand and slide the end
of the hose into the hose wand base.
Snap the hose into the upper hose clip
on handle.
6.
Slide the extension wand and crevice tool
together into storage clip.
7.
Snap the combination tool into the
storage clip.
Select models only:
8.
The TurboBrush® Tool bracket slides into
the front of the handle. Attach the bracket
by aligning the pegs with the holes on
the handle and pulling down until it locks
into place.
9.
Place the TurboBrush® Tool in the bracket
by aligning the bottom of bracket with
the opening of the brush roll and snap
the TurboBrush® Tool into place.
WARNING:
!
Plastic packaging can be
dangerous. To avoid danger
of suffocation, keep away
from babies and children.
6
2
4
8 9