Setting The Dial Mode; Setting The Flash Time; Setting The Area Code - Motorola L704CM User Manual

4. When the other handset answers the intercom call,
press MENU on the calling handset to set up the
conference call.
5. Press /BACK on any handset to end a three-
party conference call and leave the other handset
engaged with the caller.
NOTE
During an external call on the corded base, pressing
/FLASH or /SPEAKER on any cordless handset
will join in the call and set up a conference call.
4.15

Setting the dial mode

The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to
SETUP BS
select .
2. Press MENU to select
3. Press MENU and then VOL+ or REDIAL/VOL- to
TONE PULSE
select or .
4. Press MENU to save.
NOTE
If the pulse mode is selected, press */TONE to switch
from pulse to tone dialing temporarily when dialing out.
After the call is ended, the dial mode will change back
to pulse.
34
DIAL MODE
.
4.16

Setting the flash time

The default flash time is 600MS. It is unlikely that you should
need to change this setting unless advised to do so.
1. Press MENU and then VOL+ or REDIAL/VOL- to
SETUP BS
select .
2. Press MENU and then VOL+ or REDIAL/VOL- to
FLASH TIME
select .
3. Press MENU and then VOL+ or REDIAL/VOL- to
the flash time you want. (8 options are available :
90 100 110 250 300 400
, , , , ,
4. Press MENU to save.
4.17

Setting the area code

1. Press MENU and then VOL+ or REDIAL/VOL- to
SETUP BS
select .
2. Press MENU and then VOL+ or REDIAL/VOL- to
AREA CODE
select .
3. Press MENU and then enter the area code.
4. Press MENU to save.
600 700MS
, and )
Using the phone