Panasonic CF-19CDBAXVM - Toughbook 19 Tablet PC Version Service Manual page 32

n Assembly of Inverter PCB (Applicable Model : Touch Screen Model)
Inverter Ass'y
Confirm the direction of the Inverter board when attaching.
Inverter Mil Sheet
30 35mm
The gap side is front.
Inverter Ass'y
Safety Working
Details of Cable
Avoid running
over this rib.
0 1mm
0 1mm
Attach coming over the end of steel plate by 1 to 2 mm.
0 1mm
Insert it between the ribs.
(Fit to the Cabinet.)
LCD Side Cushion E
Insulation Parts
LCD Ass'y
Details of "A"
Ensure the edge of the
conductive fabric is not
frayed.
1 2
A
mm
0 1mm
0 1mm
Attach it to the Connector and FPC.
Connector
12
PWB
FPC
TS PWB
LCD Side Cushion F
Insert it between the ribs.
Insulation Parts
Connect
(Fit to the Cabinet.)
Inverter Ass'y
Connect the Cable to the
0 0.5mm
left and right Connectors.
Sub material: Pet Tape 1
Avoid any stress on the Cable
when connecting it.
Hold the Connector part when
connecting/disconnecting.
LCD Cable TS
Wind round the LCD Cable
a few times and attach it.
Sield Sheet
Fix the two Cables.
Avoid getting under the Sheet.
Insulation Parts
Insulation Parts
Connect
Avoid any stress on the Tab part of the
LCD Module because the line comes off.
Wrap of Antenna Cable
Cushion E
9-11
Avoid any stress on the Cable when
connecting the CCFL Cable.
Hold the Connector part when
connecting/disconnecting.
LCD Side Cushion E
Insert it between the ribs.
(Fit to the Cabinet.)
Cushion High
Voltage Label
0 3mm
Tape
Attach the Inverter Ass'y in the
middle of right and left.
Attach the surplus of the right and left sides on the
Back Dumper as shown below and overlap on the
CCFL Cable. Attach the Pet Sheet over the Core.
Note for attaching Conductive Tape
Conductive Tape
Inverter Ass'y
LCD Back Dumper
0 4mm
6 2mm from the
branch point
Conductive Tape
Wrap over the Antenna Cable
Cushion and the Cable.