Panasonic DP-8035 Operating Instructions Manual page 170

Setting Your Machine
Fax Parameter Table
No. Parameter
054 Fax Forward
056 Cover Sheet (HOME)
077 Department Code
078 Rotation XMT
082 Quick Memory XMT
086 Ringer Volume
089 List Output Tray
095 Duplex Print
097 Special Tray
NO.1 - 4
099 Memory Size
(Flash Memory)
118 FAX Function Detect
131 Job Tracking
170
Setting
Invalid Selecting whether the machine performs Fax Forwarding to the specified
Valid destination.
Off Setting the home position of the Cover Sheet parameter in the Select Mode.
On (See page 96)
Invalid Selecting whether the machine performs the Department Code operation.
Valid (See pages 112-117)
Invalid Selecting whether the machine performs rotation transmission.
Valid
Invalid Selecting whether the machine performs Quick Memory Transmission.
Valid Invalid : Stores all documents into memory first before dialling the
telephone number.
Valid : Starts dialling the telephone number immediately after storing the
first page.
Off Setting the home position of the ringer volume when your machine
Soft receives a call.
Loud
Upper Selecting the Output Tray home position for List printout.
Bottom Upper : The List printout exits to the Upper Output Tray.
Bottom : The List printout exits to the Bottom Output Tray.
Invalid Selecting whether the machine performs duplex print when A4/Letter originals
Valid are received.
None Select up to 4 Special Trays that will not be used for printing received faxes
Tray 1 (4-Trays, plus LCT configuration). One Tray must always be available for
Tray 2 receiving Faxes.
Tray 3 (You can specify one Tray (1 ~ 4, LCT) for each selection No. 1, No. 2, No. 3
Tray 4 and/or No. 4)
LCT
- Displays the amount of base and optional memory installed.
(Base Memory + Optional Memory)
Invalid Setting the number of digits for detecting a Fax Telephone number.
4-Digits Upon detecting the specified number of digits, the machine will
5-Digits automatically switch to the FAX Mode when it is in the Copier Mode. 4-Digits
6-Digits
7-Digits
8-Digits
None None : Select Job Tracking function
Tx Tx : Valid only in sending
Rx Rx : Valid only in receiving
Tx & Rx Tx & Rx : Valid both in sending and receiving
The Job Tracking is available under the following conditions. When "55 User
Authentication" in General Settings is set to "Fax(On)" or "Scanner(On)",
and "54 Fax Forward" in Fax Parameters is set to "Invalid".
Comments