Panasonic AWHE60H Operating Instructions Manual page 68

Controls and settings from web screen
Image capture size [QVGA, VGA]
<Initial setting: VGA>
QVGA or VGA is selected here as the H.264 image
resolution.
Transmission priority
[Constant bit rate, Frame rate]
<Initial setting: Constant bit rate>
The transmission mode of the H.264 images is set here.
Constant bit rate
Frame rate
Note
p  When "Frame rate" is selected as the "Transmission
priority" setting, there may be a reduction in the
number of users who can be connected.
Frame rate
[1fps, 3fps, 5fps*, 7.5fps*, 10fps*, 15fps*, 20fps*,
30fps*]
<Initial setting: 30fps*>
The frame rate of the H.264 images is set here.
Notes
p  This setting can be selected only when "Frame rate"
has been selected as the "Transmission priority"
setting.
p  "Frame rate" is linked to "Max bit rate (per client)*".
If a value indicated by an asterisk (*) has been
selected, the frame rate (image refresh interval)
may become slower.
68
The H.264 images are
transmitted at the bit rate which
was set by "Max bit rate (per
client)*".
The H.264 images are
transmitted at the frame rate
which was set by "Frame rate".
(continued)
Max bit rate (per client)*
[64kbps, 128kbps*, 256kbps*, 384kbps*,
512kbps*, 768kbps*, 1024kbps*, 1536kbps*,
2048kbps*, 3072kbps*, 4096kbps*, Unlimited*]
<Initial setting: 4096kbps*>
The H.264 bit rate per client is selected here.
Notes
p  "64kbps" or "128kbps" can be selected only when
QVGA or VGA has been set.
p  "Unlimited*" can be selected only when "Frame rate"
has been selected as the "Transmission priority"
setting.
p  The H.264 bit rate is linked to the "Bandwidth
control(bit rate)" of the network setting (see page 89).
If a value indicated by an asterisk (*) is selected,
the bit rate may become slower than the value
which has been set.
Image quality
[Low(Motion priority), Normal,
Fine(Image quality priority)]
<Initial setting: Normal>
The image quality of the H.264 images is selected here.
Note
p  This setting can be selected only when "Constant
bit rate" has been selected as the "Transmission
priority" setting.
Refresh interval
[0.2s, 0.33s, 0.5s, 1s, 2s, 3s, 4s, 5s]
<Initial setting: 3s>
The H.264 image refresh interval (1-frame interval:
0.2 seconds to 5 seconds) is selected here.
When there are many errors in the network environment,
setting a short refresh interval reduces the disturbance in
the images.
However, the image refresh speed may also be reduced.