Genlock Adjustment (Aw‑He60S Only) - Panasonic AWHE60H Operating Instructions Manual

Genlock adjustment (AW‑HE60S only)
q Color phase adjustment
p
The color phase adjustment must be performed if the
pictures are to be switched using a video switcher or other
device when the video output signals have been set as
composite signals.
It need not be performed when the video output signals have
been set as component signals.
The camera's color phase is aligned with the program output
(split color bar output) signals of a color special effect device
or other color tones that will serve as the reference.
(The color phase can be adjusted more accurately if a
vectorscope is used for the adjustment.)
When performing the operations
using the wireless remote control
1
Press the [MODE] button.
The mode is switched to the color bar display.
2
Follow the operation steps in "Basic
operations" (page 34) to display the Top Menu.
3
Press the [] or [] button to bring the cursor
to "System".
Top M e n u
Ca mera
Sy stem
Ma inte n a n c e
30
Color bar of camera
Split line
Color bar of special
effects generator
S c e n e : F u l l A u t o
(continued)
4
Press the [] button.
The "System" sub-menu is displayed.
S y s t e m
G e n l o c k
O u t p u t
O t h e r
R e t u r n
5
Press the [] or [] button to bring the cursor
to "Genlock", and press the [] button.
The "Genlock" sub-menu is displayed.
G e n l o c k
H o r i z o n t a l P h a s e
S u b c a r r i e r P h a s e
C o a r s e
F i n e
H P h a s e . S C F i n e S t e p
R e t u r n
6
Press the [] or [] button to bring the cursor
to "Coarse" or "Fine" of "Subcarrier Phase",
and press the [] button.
The "Coarse" or "Fine" value starts blinking.
7
Press the [] or [] button to change the
"Coarse" or "Fine" value of "Subcarrier Phase",
adjust the value so that the color phase is
brought into alignment, and press the []
button.
8
Press the [MENU] button for 2 seconds.
The menu display is exited.
9
Press the [MODE] button.
The mode is switched to the camera picture display.
0
9 0 °
0
1