Manually Adjusting The Shutter Speed - Panasonic AWHE60H Operating Instructions Manual

Manual shooting
w Manually adjusting the shutter
p
speed
The shutter speed can be set using two methods. One is
a method that specifies the time (where a time such as
1/250 sec. is designated), and the other is a method that
specifies the frequency (where synchro scan, 60.24 Hz*, etc.
is designated).
When shooting a TV screen or PC monitor screen, the
horizontal noise generated when the screen is shot can
be minimized by adjusting the frequency to the screen
frequency using synchro scan.
*: This describes when the AW‑HE60HN/AW‑HE60SN is used.
When performing the operations
using the wireless remote control
Perform the adjustments on the Camera menu.
For further details, refer to the [Shutter Mode] and
[Step/Synchro] items on page 42.
When performing the operations using the controller
The procedure is the same as for "When performing the
operations using the wireless remote control" in "Basic
operations" (pages 32 to 39).
When the AW‑RP555 is connected:
1
Press the [SHUTTER] button and turn its lamp
on.
The shutter speed set ahead of time is selected.
2
If necessary, press the [SHUTTER] button to
turn its lamp off in order to return the shutter to
the OFF setting.
18
(continued)
q How to set the shutter speed using the AW‑RP555
p
1
With the [MEMORY] button still held down,
press the [SHUTTER] button.
The [PRESET] [1] to [5] and [6] to [10] buttons blink
alternately.
2
Press one of the [1] to [8] buttons or the
[10] [PRESET] button — whichever button
corresponds to the shutter speed which is to
be set.
Any of the shutter speeds in the table below can be set.
[When 59.94 Hz has been set as the unit's frequency]
[1] [2]
1/100 1/250
[6] [7]
1/4000 1/10000
[When 50 Hz has been set as the unit's frequency]
[1] [2]
1/120 1/250
[6] [7]
1/4000 1/10000
p  Any change in the shutter speed is reflected the next
time the [SHUTTER] button is pressed and its lamp is
turned on.
p  When OFF is selected, the shutter will not operate
even when the [SHUTTER] button is pressed.
p  Select the synchro scan setting on the menu.
p  The shutter speed setting performed here is stored in
the memory even when the power of the AW-RP555
is turned off.
For further details, refer to the Operating Instructions of the
AW-RP555.
[3] [4] [5]
1/500 1/1000 1/2000
[8] [10]
Synchro Scan OFF
[3] [4] [5]
1/500 1/1000 1/2000
[8] [10]
Synchro Scan OFF