Dispenser Box; Safety Information - Zanussi ZWQ 6100 User Manual

Dispenser box

Safety Information

Please read these points carefully before installing and
using your appliance. Keep this user manual with your
appliance.
General safety
• Do not modify or attempt to modify this appliance.
This would put yourself in danger.
• Ensure that all coins, safety pins, brooches, screws
etc have been removed before starting a washing pro-
gramme. If left in washing, they can seriously dam-
age the appliance.
• Use the recommended quantity of detergent.
• Put small items together (socks, belts etc.) in a small
linen bag or pillow case.
• Unplug and close inlet hose tap after using appliance.
• Always disconnect the power supply from the appli-
ance before cleaning or maintenance.
• Do not machine wash clothes with ribbing, unfinish-
ed or torn material.
Installation
• Unpack or ask for the appliance to be unpacked im-
mediately upon delivery. Check the outside of the ap-
pliance is not damaged in any way. Report all transit
damage to your retailer.
• Remove all transit bolts and packaging before instal-
ling the appliance.
• Connection to the water supply must be carried out
by a qualified plumber.
• If your domestic electrical circuit needs adapting to
allow the appliance to be plugged in, use a qualified
electrician.
• Ensure that, after installation, the power cable is not
trapped under the appliance.
Prewash
Wash
Softener (do not fill above the MAX symbol
• If the appliance is installed on carpeted floor, ensure
that the carpet does not obstruct any ventilation
ducts located at the base of the appliance.
• The appliance must be equipped with an earthed pow-
er plug which conforms to regulations.
• Before connecting your appliance to the power sup-
ply, carefully read the instructions in the chapter enti-
tled "Electrical connection".
• Replacing the power cable should only be carried out
by an authorised service engineer.
• The manufacturer cannot be held responsible for any
damage resulting from incorrect installation.
Precautions to be taken against frost
If your appliance is exposed to temperatures below 0°C,
the following precautions must be taken:
• Close the tap and disconnect the inlet hose.
• Place the end of this hose and the drain hose in a
basin on the floor.
• Select the Drain programme let it run until the end of
the cycle.
• Disconnect the appliance from the power supply by
turning the programme selector to "Stop"
• Unplug the appliance.
• Replace the inlet hose and drain hose.
This way, the water remaining in the hoses will be
drained away, avoiding any ice formation which would
damage your appliance.
Before turning your appliance on again, ensure that it is
installed in an area where the temperature will not fall
below freezing.
)
M
.
3