Operating Sequence; Washing Only - Zanussi ZWD 12270 G1 User Manual

Operating sequence - Washing only
Washing
possible. Close the door.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out the prewash phase,
pour it into the compartment marked
If required, pour fabric softener into the
compartment marked
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by turning
the programme selector dial (
Turn the programme selector dial to the
required programme. The green light of button
6
starts to flash.
On position «Off» the programme is reset and
the machine is switched off.
18
1. Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in
the drum, one item at
a time, shaking them
out as much as
.
(the amount used
1
)
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red light of button
times and the message Err is displayed to
indicate a wrong selection. The machine will
not perform the new selected programme.
Select the spin speed or No Spin or Rinse
Hold option by pressing button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate (refer to the
section «Programme table» for the maximum
allowed by each cycle spin speed). The
relevant light will light up.
Select the desired option by pressing the
3 4
buttons and
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before pressing the button
relevant light will light up.
In any case, if an option is chosen that is not
allowed with the selected programme, the
message Err will be displayed on the display
for a few seconds, and the red light of the
button 6 start flashing.
IMPORTANT!
For the compatibility of the options with the
washing programmes, please refer to the
«Programme table».
6
will flash 3
2
6
. The