Operating Sequence; Washing Only - Zanussi W802 Instruction Booklet

Operating sequence

Washing only

Before washing your first load of laundry, we
recommend that you run a cotton cycle at 60°C, with
the machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
P0004
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash, pour detergent
into the appropriate compartment marked
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
C0064
4. Depress button
.
.
C0065
if required
5. Select the temperature and the
required programme
Turn the dial to the required temperature and the
programme selector dial clockwise to the desired
position.
M0045
6. Start the machine
Depress the ON/OFF button: the mains-on light will
illuminate and the machine starts operating.
P0080
7. At the end of the programme
The machine stops automatically.
If you have selected a programme which ends with
the water of the last rinse in the tub, drain the water
before opening the door by selecting programme P
(drain) or J (drain and short spin).
The door is controlled by a safety device which
releases 2 minutes after the end of the programme.
Switch the machine off by pressing the ON/OFF
button . The mains-on light goes out.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
12
M0046