Zanussi ZWD 12270 G1 User Manual page 32

Special conditions
If the floor is carpeted or covered with crumbly
or soft material, insert a rigid support base
under the feet to prevent noise, vibration or
displacement. The base should protrude a few
centimetres beyond the edges of the machine.
WARNING!
The machine should NOT be placed on deep
pile carpeting.
NOTE
Please ensure that when the appliance is
installed it is easily accessible for the engineer
in the event of a breakdown.
Water inlet
The inlet hose is already screwed on the back
of the appliance.
1. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent
leaks.
Attention !
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
2. This appliance must be connected to a
cold water supply. Connect the hose to a
tap with a 3/4" thread. The inlet hose must
not be lengthened. If it is too short and you
do not wish to move the tap, you will have
to purchase a new, longer hose specially
designed for this type of use.
32
A minimum water pressure of 0.05 MPa (0.5
bar) is required for safe operation of the
appliance.If you cannot make the cold water
connection direct from the rising mains, you
may be able to operate the appliance from
your cold water storage system.
There should be a minimum vertical distance
of 5.02m (16.5 ft) between the appliance's
inlet and the bottom of the water storage tank.
Water drainage
This appliance is designed to be permanently
plumbed into your home's drainage system
using one of the following methods.
1. Into a drainage standpipe.
Place the drain hose into your standpipe,
which should have an internal diameter of
approximately 38mm thus ensuring there is an
air break between the drain hose and
standpipe.
NOTE
Installation should
comply with local
water authority and
building
regulations'
requirements.
Firstly form a hook in
the end of the drain
hose using the «U»
piece supplied.