Overview - Toshiba PSA10C-035WM Maintenance Manual

4.1 Overview

4
4.1 Overview
This chapter describes the procedure for removing and replacing the field replaceable units
(FRUs) in the PC. It may not be necessary to remove all the FRUs in order to replace one.
The chart below provides a guide as to which other FRUs must be removed before a
particular FRU can be removed. The numbers in the chart indicate the relevant section
numbers in this manual.
In all cases when removing an FRU, the battery pack must also be removed. When repairing
an FRU that is the potential cause of a computer fault, use the chart to determine the order in
which FRUs need to be removed.
4.2
4.2 Baterry
PC Card
4.3 Memory Module
4.6 Wireless LAN Card
4.8 Keyboard
4.9 Optical Drive
4.10 Display Assembly
4.11 Touch Pad
4.12 BAT CON Holder
4.13 System Board/DC-IN Jack/RTC Battery
4.14 BAT LOCK ASSY/HDD UPPER ASSY
• Chart Notation
The chart shows the case
for the following example:
• Removing System Board
All FRUs down to the
"4.2 Battery/PC Card" to
"4.10 Display Assembly"
units must be removed.
Similarly, "4.11 Touch
Pad" and "4.12 BAT CON
Holder" must be also
removed to remove the
system board.
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)
4.4
HDD
4.15 Touch Pad Switch
4.2 4.2 Battery
PC Card
4.3 Memory Module
4.6 Wireless LAN Card
4.8 Keyboard
4.9 Optical Drive
4.10 Display Assembly
4.11 Touch Pad
4.12 BAT CON Holder
4.13 System Board/DC-IN Jack/RTC Battery
4.14 BAT LOCK ASSY/
HDD UPPER ASSY
4 Replacement Procedures
4.5 4.7 Fan Module/
MDC Cooling Fin/CPU
4.16 LCD Module/
FL Inverter
4.17 Wireless LAN Antenna/
Display Cover/Speaker
4.4 4.5
HDD MDC
4.16 LCD Module/
FL Inverter
4.17 Wireless LAN Antenna/
Display Cover/Speaker
4.15 Touch Pad Switch
4.7 Fan Module/
Cooling Fin/CPU
4-1