Table of Contents
Advertisement
18
C
2: I
HAPTER
NSTALLING THE
Installing the System in a Distribution Rack
You can mount the CoreBuilder 9400 system into a
48.26 mm (19-in.) distribution rack. This section
describes how to prepare the system and distribution
rack for installation and how to mount the system in
the rack.
Install your distribution rack near an easily accessible
power outlet. You can power down the system only
by removing the power cord from the power source.
To prepare the system and distribution rack for
installing the CoreBuilder 9400 system:
See Appendix C for distribution rack requirements.
1
Attach one of the L-shaped mounting brackets to one
2
side of the CoreBuilder 9400 using the 8-32 x 1/2
Phillips flat-head screws. Attach the other bracket to
the other side. See Figure 4.
S
YSTEM
Figure 4 Installing System Mounting Brackets
Mounting screws
Mounting bracket
Carefully lift the system into place, aligning the
3
bracket holes with the distribution rack holes.
While you hold the system in place, insert the four
4
mounting screws (10-32 x 1/2 Phillips pan-head) into
the mounting holes on each side of the rack.
Tighten the mounting screws.
5
You are now ready to cable the system. For cabling
instructions, see Chapter 3.
3C94024
R
1000BASE SX
1
2
TX
RX
TX
RX
TX
1000BASE SX
TX
4
RX
TX
5
RX
TX
1000BASE SX
TX
7
RX
TX
8
RX
TX
1000BASE SX
TX
10
RX
TX
11
RX
TX
Advertisement
Table of Contents
