Specifications; Amplifier Section; Active Subwoofer - Panasonic SC-HTB370 Owner's Manual

There is no audio.
The power of the main unit turns off
automatically.
(When the main unit detects a problem, a safety measure
is activated and the main unit automatically switches to
standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?
If so, lower the volume.
≥ Is this system placed in an extremely hot place?
If so, move this system to a cooler place and wait a few
moments and then try to turn it on again.
If the problem persists, confirm the TV indicator and
BD/DVD indicator blink, turn this system off, remove the
AC power supply cord and consult your dealer. Please be
sure to remember the indicators that were blinking and
inform the dealer.

Active Subwoofer

No power.
Ensure the AC power supply cord of the active subwoofer
is connected properly.
After turning the subwoofer on, it immediately
turns off.
Unplug the AC power supply cord and consult your dealer.
No sound from the subwoofer.
≥ Check that the active subwoofer is turned on.
≥ Check that the WIRELESS LINK indicator lights green.
( 24)
The WIRELESS LINK indicator lights red.
≥ There is no link between the main unit and the active
subwoofer.
j Check that the main unit is turned on.
j Turn the active subwoofer off and then back on.
Alternatively, turn the active subwoofer off,
disconnect the AC power supply cord and then
reconnect it.
≥ The active subwoofer and the main unit may not be
paired correctly. Try the following operation. (Wireless
pairing)
1 Turn on the main unit and active subwoofer.
2 Press [ID SET] on the rear of the active subwoofer
for more than 3 sec.
(The WIRELESS LINK indicator will blink in red.)
3 While pressing and holding [INPUT SELECTOR] on
remote control, press and hold [VOL i] on the main
unit for more than 4 sec. (The BD/DVD indicator will
blink and sound mode indicators light up in
sequence.)
≥ When the wireless pairing is successful, BD/DVD
indicator will stop flashing and WIRELESS LINK
indicator lights green.
4 Turn the main unit off and on.
≥ Consult your dealer if the problem persists.
30
RQT9777

Specifications

AMPLIFIER SECTION

RMS output power: Dolby Digital Mode
Front ch (L, R ch)
60 W per channel (6 ≠), 1 kHz, 10 % THD
Subwoofer ch
120 W per channel (8 ≠), 100 Hz, 10 % THD
Total RMS Dolby Digital mode power
FTC output power: Dolby Digital Mode
Front ch (L, R ch)
120 Hz to 20 kHz, 1.0 % THD
Subwoofer ch
Total FTC Dolby Digital mode power
WIRELESS SECTION
Wireless module
Frequency Range
2.40335 GHz to 2.47735 GHz
No. of channels
TERMINAL SECTION
Digital audio input
Optical digital input (TV, BD/DVD)
Sampling frequency
88.2 kHz, 96 kHz (only LPCM)
Audio format
LPCM, Dolby Digital, DTS Digital Surround
Analog audio input
Aux input (AUX)
USB Port
25 W per channel (6 ≠),
40 W per channel (8 ≠),
60 Hz to 120 Hz, 1.0 % THD
32 kHz, 44.1 kHz, 48 kHz
For service use only.
240 W
90 W
38
2
1