Power Supply Preparation General Setup; Using The Ac Adaptor - Nextar SNAP3 - Automotive GPS Receiver Hardware Instruction Manual

Power Supply
Preparation

Using the AC Adaptor

The unit is supplied with an AC adaptor for powering and charging its battery.
1. Connect AC adaptor to the right side
of the unit in the USB port, as shown
on the right.
2. Plug the two-prong end of the power
cord into a grounded electrical
outlet.
Note:
 Turn unit's power off before unplugging.
 When using the adaptor, the LCD screen will be brighter than with the
rechargeable battery.
Using the Car Adaptor
The unit is supplied with a Car Adaptor for powering while in a vehicle.
Connect the Car Adaptor Power Plug to
the unit's USB port and plug the other
end to the vehicle's 5V accessory/
cigarette socket, as shown on the right
figure.
Attention
 Place the unit in a proper position for viewing.
 Disconnect the unit from the Car Adaptor when starting the vehicle.
Your portable GPS unit comes with a built-in rechargeable battery. Please see details in
the following segment.
10