Asus P5GC MX 1333 - Motherboard - Micro ATX User Manual page 39

2. IDE connectors (40-1 pin PRI_IDE)
The onboard IDE connectors are for Ultra DMA 100/66/33 signal cables.
There are three connectors on each Ultra DMA 100/66/33 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard's IDE
connector, then select one of the following modes to configure your device(s).
P5GC-MX/1333
Single device
Two devices
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE devices.
If any device jumper is set as "Cable-Select," make sure all other device
jumpers have the same setting.
ASUS P5GC-MX/1333
IDE Connector
Drive jumper
setting
Cable-Select or Master
Cable-Select
Master
Slave
Mode Cable
of device(s) connector
- Black
Master Black
Slave Gray
Master
Black or gray
Slave
1-27