Page 1
U s e r I n s t r u c t i o n s ESF 631 ANC 822 945 701 - 00 - 0600...
Page 2
Dear customer, Please read these user instructions carefully. Above all please observe the safety instructions on the first few pages ofthese user instructions! Please keep these user instructions for later reference. Pass them on to any subsequent owner of the appliance. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for...
Safety Instructions The safety aspects of ELECTROLUX electrical appli- ances comply with accepted technical standards and the German Appliance Safety Law. Nevertheless, as a manufacturer we consider it our obligation to make you aware of the following safety information: Installation, Connection and Plac- ing into Operation •...
Disposal of old appliances As and when you cease to use your dishwasher, please take it to a recycling centre or to your dealer who will, for a small contribution to the costs, dispose...
Economical and Ecological Dishwash- • Only connect the dishwasher to the hot water sup- ply if your hot water is not electrically heated. • Ensure that the water softener is correctly adjusted. • Do not pre-rinse dishes under running water.
Appliance Features and Control Panel Rubber Seal for Con- necting Water Feed to the Upper Spray Arm Spray Arms Water Hardness Switch Container for Special Salt Container for Rinse Aid Container for Detergent Rating Plate Filters...
Control panel Programme Selector Switch on the dishwasher and start a wash pro- gramme using the programme selector. Programme Switch Door Handle Set the point at which the wash programme is to start using the programme switch. The programme switch rotates during the wash programme and indi- cates the position that has been reached in the pro- gramme.
Adjusting the Water Softener To prevent the build up of scale on dishes and in the dishwasher, the dishes must be washed with soft, i.e. low lime content water. For this reason the dish- washer is fitted with a water softener in which tap water from a hardness of 4 °d (German degrees) is...
Fill with special salt: • Prior to using the dishwasher for the first time • If a green mark can be seen under the lid of the special salt container, then there is sufficient spe- cial salt.
This would damage the appliance. Fill with rinse aid: • Prior to using the dishwasher for the first time. • When a dark point surrounded by a light ring is to be seen in the indicator window on the container.
– Do not lay small objects (e.g. lids) in the cutlery rack are of limited suitability: – Only wash stoneware in the dishwasher if it is spe- cifically marked as being dishwasher-safe by the manufacturer. – Glazed patterns may fade if machine washed fre- quently.
1. Place the grid insert on the cutlery rack 2. Place short knives, forks and spoons in the grid insert with their handles pointing downwards. Some models of dishwasher have cutlery baskets without a cutlery grid. Loading Pans, Frying Pans and...
Loading Cups, Glasses and Coffee Services Load small, delicate items and long pointed cutlery in the upper rack. • Arrange plates and dishes offset on and under the folding cup racks so that washing water can reach all items. • The cup racks can be folded up out of the way for tall items.
Filling with Detergent Use only dishwasher detergent. Fill with Detergent: Prior to the start of a wash programme (not for the Pre Wash programme). The detergent is released into the wash water during the programme. Please observe the manufacturer’s dosing and storage recommendations given on the detergent packaging.
Selecting the Wash Programme (Programme Table) Choose the most suitable wash programme with the aid of this table: Type of Dinner Service and Cooking Utensils Dishes: In Addition: Type of normally Soiling: soiled dried left-overs Suitable Programme: NORMAL 65 °C Turn programme switch to:...
Hot steam can escape when the door is opened. There is a risk of scolding! Open the door carefully. 1. Open the door of the dishwasher. The wash pro- gramme stops. 2. Shut the door. The wash programme continues.
1. Open the door, remove the lower rack. 2. The dishwasher filter system comprises a coarse/ fine filter, microfilter and a flat filter. Unlock the fil- ter system using the handle on the microfilter, and remove.
What to do, when ... Try to rectify minor faults on the dishwasher with the aid of the instructions given here. If you call in cus- tomer service to resolve one of the malfunctions listed here, or rectify an error made in the operation of the appliance, the customer service engineer’s visit...
Pressure: Electrical Connection: Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher door on the right. Dishwasher: Free-Standing Appliances Dimensions: 850 x 600 x 600 (H x B x D in mm) Max.
Notes for Test Institutes The salt container for the water softener and the rinse aid container must be completely full prior to the test. Test Standard: EN 50 242 Comparative Program: see "Program table: Test programme" for full and half load Full Load: 12 place settings incl.
Page 23
Example Loading Arrangements: Bottom rack Example Loading Arrangements: Cutlery basket...
INSTALLATION AND CONNECTION INSTRUCTIONS Installing the Dishwasher • The dishwasher must be installed on a firm floor and adjusted to ensure that it is stable and level. • To compensate for unevenness in the floor and to match the height of the appliance to that of sur- rounding units extend the threaded feet by unscrewing.
Depending on type, the dishwasher is to be installed as follows: Dishwashers That Can Be Inte- grated (see installation template supplied) The door of the appliance can be fitted with a wooden furniture door with the following dimensions Width: 591 – 594 mm Thickness: 16 –...
Page 26
If the dishwasher is later used as a free- standing appliance, the original work surface must be re-mounted. The plinth on free-standing appliances is not adjustable. • Free-standing appliances can be fitted with a décor panel to match the facings of other kitchen equipment.
Connecting the Dishwasher Water connection The dishwasher is fitted with safety devices that pre- vent the return of wash water into the drinking water system and comply with the applicable plumbing reg- ulations. • The dishwasher can be connected to cold and hot water supplies up to max.
Leak Prevention System For protection from damage due to water leaks, the dishwasher is equipped with a leak prevention sys- tem. In the event of a fault, the drain pump switches on. By this means water can neither escape nor overflow.
Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.
The example plumbing and electrical installation given below can only be regarded as a recommenda- tion; the actual situation where the dishwasher is to be installed will define the exact installation (available connections, local electricity and water board regula- tions for connecting up appliances, etc.).
SERVICE In the section "What to do, if..." the most important sources of faults that you can rectify yourself are summarised. If, nevertheless, you call in customer service to resolve a problem listed in these instruction, or because of an error made in operating the appliance, the customer service engineer’s visit is not free of charge, even during the warranty period.