Network Settings; Enable Netbeui - Sharp MX-2300N System Settings Manual

Network Settings

Network settings are described below. Touch the [Network Settings] key and configure the settings.
When any of these settings are changed, you must exit the system settings, turn off the [POWER] key (
interval, and then turn the [POWER] key (
IP Address Setting
When using the machine on a TCP/IP network, use this
setting to configure the IP address of the machine.
System Settings
IP Address Setting
IP Address
IP Subnet Mask
IP Gateway
Make sure that the [DHCP] checkbox is not selected
and then select each key, enter the required values with
the numeric keys, and touch the [OK] key.
To set the machine to obtain an IP address
automatically, select the [DHCP] checkbox
touch the [OK] key.
• To use the machine on a TCP/IP network, the
"Enable TCP/IP" setting must also be enabled.
• If DHCP is used, the IP address assigned to the
machine may change automatically. If the IP
address changes, printing will not be possible.
Enable TCP/IP
To use the machine on a TCP/IP network, this setting
must be enabled. The IP address of the machine must
also be configured using
To enable this setting, select the checkbox
touch the [OK] key.
Enable NetWare
To use the machine on a NetWare network, this setting
must be enabled.
To enable this setting, select the checkbox
touch the [OK] key.
OK
DHCP
and
"IP Address Setting".
and
and
) back on to make the new settings take effect.
Enable EtherTalk
To use the machine on an EtherTalk network, this
setting must be enabled.
To enable this setting, select the checkbox
touch the [OK] key.

Enable NetBEUI

To use the machine on a NetBEUI network, this setting
must be enabled.
To enable this setting, select the checkbox
touch the [OK] key.
Reset the NIC
This returns all of the settings on the print server card to
the factory default settings.
Ping Command
Use this function to check if the machine can
communicate with a computer on the network.
Specify the IP address of the desired computer and
touch the [Start] key. A message will appear indicating
whether or not the computer responded.
System Settings
Ping Command
Enter the IP Address and press [Start].
Select each key, enter the appropriate values with the
numeric keys, and touch the [Start] key.
101
IP Address
), wait a brief
and
and
OK
Start