Table of Contents
Advertisement
Active to CMD (Trcd) [3T]
Configuration options: [2T] [3T]
SDRAM Bank Interleave [Disabled]
This item controls the latency between the SDRAM read command and the
time the data actually becomes available.
Configuration options: [Disabled] [2-Way] [4-Way]
SDRAM Burst Length [4QW]
Configuration options: [8QW] [4QW]
SDRAM Command Rate [2T]
Configuration options: [2T] [1T]
AGP Mode [4X]
Allows you to set the AGP mode setting.
Configuration options: [AGP 4X] [AGP 2X] AGP 1X]
Graphics Aperture Size [64MB]
Allows you to to select the size of mapped memory for AGP graphic data.
Configuration options: [256MB] [128MB] [64MB] [32MB] [16MB] [8MB] [4MB]
Integrated AGP [Enabled/16MB]
Allows you to disable or enable and set the integrated AGP operating memory size.
Configuration options: [Disabled] [Enabled/8MB] [Enabled/16MB] [Enabled/32MB]
Primary Graphics Adapter [PCI]
This item sets the primary graphics adapter. Configuration options: [PCI] [AGP]
AddOn/Onboard VGA Select [Auto]
This item allows you to set the onboard VGA port for use or set to [Auto] to detect
an add-on VGA card. Configuration options: [Onboard VGA] [Auto]
2-12
Chapter 2: BIOS information
Advertisement
Table of Contents
