Table of Contents
Advertisement
10. System panel connector (10-1 pin PANEL1)
This connector accommodates several system front panel functions.
P4V533-MX
P4V533-MX Front Panel Audio Connector
•
System Power LED Lead (2-pin PWR LED)
This 2-1 pin connector connects to the system power LED. The LED lights up
when you turn on the system power, and blinks when the system is in sleep
mode.
•
Hard disk activity LED (2-pin HD LED)
This 2-pin connector supplies power to the hard disk activity LED. The read
and write activities of any device connected to the primary or secondary IDE
connector cause this LED to light up.
•
ATX Power Switch / Soft-Off Switch Lead (2-pin PWR BTN)
This connector connects a switch that controls the system power. Pressing the
power switch turns the system between ON and SLEEP, or ON and SOFT
OFF, depending on the BIOS or OS settings. Pressing the power switch while
in the ON mode for more than 4 seconds turns the system OFF.
•
Reset Switch Lead (2-pin RESET)
This 2-pin connector connects to the case-mounted reset switch for rebooting
the system without turning off the system power.
Important Note:
A system buzzer (BUZZ1) is added to the motherboard. The system buzzer allows
you to hear system warning beeps when a PC speaker is not available.
P4V533-MX
P4V533-MX Buzzer
1-22
®
BUZZ1
®
ATX Power
Power LED
Switch*
PANEL1
IDE_LED
Reset SW
Requires an ATX power supply.
*
Chapter 1: Product introduction
Advertisement
Table of Contents
