Operating Problems - AEG LAVAMAT 4520 User Information

User information

Operating problems

Many checks have been carried out during the manufacture of your
washing machine. However, if you face a problem with its operation,
please read the following sections before calling the After Sales
service.
Symptom
The washing machine will
not start or will not fill:
The washing machine fills
up but empties again
immediately:
The washing machine will
not spin or will not empty:
Softener or Javel water
flows through
overflow orifice
filling* :
26
Cause
• the washing machine is not correctly
connected, the electrical installation is
not working,
• the cover of your washing machine
and the drum flaps are not correctly
closed,
• you did not control the program start
correctly,
• there is a power failure,
• the water supply is closed off,
• the water tap is closed,
• the water inlet is blocked.
• the drain siphon is attached too low
(see installation section).
• the drain pipe is blocked or kinked,
• the drain filter is blocked,
• the anti-unbalance mass safety device
has tripped; bad distribution of
washing in the drum,
• the «Drain» program or the «Rinse hold»
option is selected,
• the height of the drain siphon is
wrong.
• you did not put in the right amount,
the • the siphons at the back of the deter-
when gents dispenser are blocked.