Gigabyte G1.Sniper2 User Manual page 53

Manual
Table of Contents

Advertisement

USB Controllers
Enables or disables the integrated USB controller. (Default: Enabled)
Disabled will turn off all of the USB functionalities below.
USB Legacy Function
Allows USB keyboard to be used in MS-DOS. (Default: Enabled)
USB Storage Function
Determines whether to detect USB storage devices, including USB flash drives and USB hard drives
during the POST. (Default: Enabled)
Onboard Audio
Enables or disables the onboard audio function. (Default: Enabled)
If you wish to install a 3rd party add-in audio card instead of using the onboard audio, set this item to
Disabled.
Onboard H/W LAN
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
R_USB30 Controller (Etron EJ168 USB Controller, USB 3.0/2.0 ports on the back panel)
Enables or disables the Etron EJ168 USB controller. (Default: Enabled)
F_USB30 Controller (Etron EJ168 USB Controller, USB 3.0/2.0 ports routed to the on-
board F_USB30 header)
Enables or disables the Etron EJ168 USB controller. (Default: Enabled)
GSATA3 Controller (Marvell 88SE9172 Chip, GSATA3_6 and GSATA3_7 connectors)
Enables or disables the SATA controller integrated in the Marvell 88SE9172 chip. (Default: Enabled)
GSATA3 Ctrl Mode (Marvell 88SE9172 Chip, GSATA3_6 and GSATA3_7 connectors)
Enables or disables RAID for the SATA controller integrated in the Marvell 88SE9172 chip or configures
the SATA controller to AHCI mode.
IDE
Configures the SATA controller to IDE mode. (Default)
AHCI
C onfigures the SATA controller to AHCI mode. Advanced Host Controller Interface (AHCI)
is an interface specification that allows the storage driver to enable advanced Serial ATA
features such as Native Command Queuing and hot plug.
RAID
Enables RAID for the SATA controllers.
Onboard Serial Port 1
Enables or disables the serial port and specifies its base I/O address and corresponding interrupt.
Options are: Auto, 3F8/IRQ4 (default), 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Disabled.
- 53 -
BIOS Setup

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G1.sniper 2

Table of Contents