Gigabyte G1.Sniper2 User Manual page 11

Storage Interface Chipset:
Š
- 2 x SATA 6Gb/s connectors (SATA3_0, SATA3_1) supporting up to 2 SATA
6Gb/s devices
- 3 x SATA 3Gb/s connectors (SATA2_2~SATA2_4) supporting up to 3 SATA
3Gb/s devices
- 1 x eSATA 3Gb/s connector (eSATA/USB Combo connector) on the back
panel supporting up to 1 SATA 3Gb/s device
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the
USB Chipset:
Š
- Up to 14 USB 2.0/1.1 ports (8 ports on the back panel, including 1 eSATA/
USB Combo connector, 6 ports available through the internal USB
headers)
2 x Etron EJ168 chips:
Š
- Up to 4 USB 3.0/2.0 ports (2 ports on the back panel, 2 ports available
through the internal USB header)
Internal 1 x 24-pin ATX main power connector
Š
Connectors 1 x 8-pin ATX 12V power connector
Š
4 x SATA 6Gb/s connectors
Š
3 x SATA 3Gb/s connectors
Š
1 x CPU fan header
Š
4 x system fan headers
Š
1 x front panel header
Š
1 x front panel audio header
Š
1 x S/PDIF Out header
Š
3 x USB 2.0/1.1 headers
Š
1 x USB 3.0/2.0 header
Š
1 x serial port header
Š
1 x Trusted Platform Module (TPM) header
Š
1 x clearing CMOS jumper
Š
1 x heatsink LED power connector
Š
1 x CPU overclocking button header
Š
Back Panel 7 x USB 2.0/1.1 ports
Š
Connectors 1 x PS/2 keyboard/mouse port
Š
1 x CPU overclocking button
Š
1 x optical S/PDIF Out connector
Š
1 x eSATA/USB Combo connector
Š
1 x HDMI port
Š
2 x USB 3.0/2.0 ports
Š
1 x RJ-45 port
Š
5 x audio jacks (Center/Subwoofer Speaker Out, Rear Speaker Out, Side Speaker
Š
Out, Line In/Mic In, Line Out)
system performance of the RAID set may vary depending on the devices being
connected.
- 11 - Hardware Installation