Figure 8-28: Current VPN Tunnels (SAs) Screen
c. Look at the VPN Status/Log screen
VPN Tunnel Control
Activating a VPN Tunnel
There are three ways to activate a VPN tunnel:
•
Use the VPN Status page.
•
Activate the VPN tunnel by pinging the remote endpoint.
•
Start using the VPN tunnel.
Note: Refer to
"Using Auto Policy to Configure VPN Tunnels" on page -36
keepalive capability on an existing VPN tunnel.
Using the VPN Status Page to Activate a VPN Tunnel
To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
1. Log in to the ADSL Modem Router.
Virtual Private Networking
(Figure
8-27) to verify that the tunnel is connected.
v3.0, September 2005
DG834G Reference Manual
to enable the IKE
8-27