Vpn Tunnel Control; Activating A Vpn Tunnel; Using The Vpn Status Page To Activate A Vpn Tunnel - NETGEAR DG834Gv1 - 54 Mbps Wireless ADSL Firewall Modem Reference Manual
Wireless adsl firewall router
Hide thumbs
Also See for DG834Gv1 - 54 Mbps Wireless ADSL Firewall Modem:
- Specifications (2 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
Figure 8-29: Current VPN Tunnels (SAs) Screen
Look at the VPN Status/Log screen
c.
VPN Tunnel Control
Activating a VPN Tunnel
There are three ways to activate a VPN tunnel:
•
Use the VPN Status page.
•
Activate the VPN tunnel by pinging the remote endpoint.
•
Start using the VPN tunnel.
Note: Refer to
"Using Auto Policy to Configure VPN Tunnels" on page 8-36
keepalive capability on an existing VPN tunnel.
Using the VPN Status Page to Activate a VPN Tunnel
To use the VPN Status screen to activate a VPN tunnel, perform the following steps:
Log in to the Router.
1.
Open the DG834G management interface and click on VPN Status to get the VPN Status/Log
2.
screen
(Figure
8-30).
Virtual Private Networking (Advanced Feature)
Reference Manual for the Model Wireless ADSL Firewall Router DG834G
(Figure
202-10006-05, June 2005
8-28) to verify that the tunnel is connected.
to enable the IKE
8-27
Advertisement
Table of Contents
Troubleshooting
