NETGEAR DG834GUv5 Reference Manual page 139

To activate the VPN tunnel by pinging the remote endpoint (e.g., 192.168.3.1), do the following
steps depending on whether your configuration is client-to-gateway or gateway-to-gateway:
• Client-to-Gateway Configuration—to check the VPN Connection, you can initiate a request
from the remote PC to the DG834G's network by using the "Connect" option in the
NETGEAR ProSafe menu bar. The NETGEAR ProSafe client will report the results of the
attempt to connect. Since the remote PC has a dynamically assigned WAN IP address, it must
initiate the request.
To perform a ping test using our example, start from the remote PC:
a. Establish an Internet connection from the PC.
b. On the Windows taskbar, click the Start button, and then click Run.
c. Type
ping -t 192.168.3.1
Figure 8-31: Running a Ping test to the LAN from the PC
This will cause a continuous ping to be sent to the first DG834G. After between several
seconds and two minutes, the ping response should change from "timed out" to "reply."
Note: Use Cntl-C to stop the pinging.
Figure 8-32: Ping test results
Virtual Private Networking
and then click OK.
v3.0, September 2005
DG834G Reference Manual
8-29