Automatic Transmission Fluid - Acura 2008 RL Owner's Manual

Hide thumbs Also See for 2008 RL:
Table of Contents

Advertisement

UPPER MARK
LOWER MARK
3.
Insert the dipstick all the way into
the transmission as shown.
4.
Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.
5.
If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Pour the fluid slowly and carefully
so you do not spill any. Clean up
any spill immediately; it could
damage components in the engine
compartment.
Always use Honda ATF-Z1

(automatic transmission fluid).

Use only Honda Genuine ATF-Z1
(Automatic Transmission Fluid). Do
not mix with other transmission f luids.
Using transmission f luid other than
Honda Genuine ATF-Z1 may cause
deterioration in transmission operation
and durability, and could result in
damage to the transmission.
Damage resulting f rom the use of
transmission f luid other than Honda
Genuine ATF-Z1 is not covered by the
Honda new vehicle warranty.
Automatic Transmission Fluid
6.
Insert the dipstick all the way back
into the transmission securely as
shown in the illustration.
The transmission should be drained
and refilled with new fluid when this
service is shown by a maintenance
message on the multi-information
display.
If you are not sure how to add fluid,
contact your dealer.
405

Advertisement

Table of Contents
loading

Table of Contents