6.5.16 Removing/Replacing the Charger Board
Use the following procedure to remove/replace the Charger Board:
1.
Remove the Top Cover as described in Paragraphs 6.5.10 respectively.
2.
Separate the inside frame assembly from the base assembly as shown in Figure 6-18.
3.
Turn the unit over and remove the screw holding the Charger Board to the inside of the Frame
Assembly (Figure 6-20). Remove the Charger Board.
4. To reinstall the Charger Board, reverse the removal procedure.
Figure 6-20
Removing/Replacing the Charger Board Assembly
6-18
Field Service