Table of Contents
Advertisement
6.5.9 Removing/Replacing the Display Assembly
Use the following procedure to remove/replace the display assembly:
1.
Remove the battery and AC adapter as described in Paragraph 6.5.1.
2.
Refer to Figure 6-12 and remove the two screws that secure the display cable to the
Motherboard assembly. Then unplug display cable J19
Figure 6-12
Unplugging the Display Cable
3.
Remove the four display hinge screws (Figure 6-13) and separate the Display Assembly from
the Base Assembly.
4.
Installation is the reverse of Steps 1 through 3.
Figure 6-13
Removing the Display Hinge Screws
6-12
Field Service
Advertisement
Table of Contents
Troubleshooting
